QCM DP5011 CURABLE REDUCER FOR PLASTISOL INK

Your Price: $0.00
Part Number:ANC00632

Choose Options

Container Sizes
1 Gallon
5 Gallon
Quart

P-5011
Curable Reducer
Product Overview:
P-5011 Curable Reducer is a 100% solids plastisol reducer that can be added to any plastisol product to reduce the viscosity of the
ink. P-5011 curable reducer is fully curable by itself.
Printing:
QCM recommends a starting point of mixing in 2% - 5% P-5011 (by weight) to the ink you need to thin out. Depending on the ink,
you may add up to 10% before affecting the inks opacity; however, it is always recommended that you do a test print to check
opacity after any clear ink is added. Taut screens (25 newtons or higher) are strongly recommended. If using lower tension
screens adjust off contact accordingly. Recommend a 70 durometer sharp squeegee for best deposit.

Stencil:
Use any direct emulsion or capillary film.
Additives:
None
Flashing:
Parameters vary between all flash units. Flash for 2-3 seconds with the ink deposit reaching 150-250°F (65-121°C
Curing:
Cure at 325°F (162°C) over a 60-90 second period depending on oven type and thickness of ink deposit. A thicker deposit will take
longer to cure as the heat must penetrate through the entire ink layer.
Cleanup:
Use any of the commercially available products for the cleanup of plastisol inks.
Environmentally Friendly:
QCM Plastisol Ink contains no leaded pigments and, when properly disposed of, has no environmental impact. Use a screen wash
for plastisols for cleanup. Scrape screens carefully and store ink for reuse. Minimize unusable scrap ink by segregating ink by color.
QCM PPR-901 Black pigment can be used to convert old ink into black ink for waste elimination.