WOW-9017 Softee Black is a super soft, buildup free jet black ink that can be printed by itself or in sequence/wet-on-wet. It is the
black ink of choice where a super soft, water base like print finish is desired.
WOW-9017 Softee Black will print exceptionally well through screen meshes in the range of 110-435. The higher the mesh, the
softer the finished print. Screens stretched to a minimum of 25 newtons are recommended. If using lower tension screens, adjust
off contact accordingly. Recommend a 70 to 70/90/70 durometer sharp squeegee. Hard squeegee pressure is recommended to
assure the extreme soft hand.
Use any direct emulsion or capillary film.
Parameters vary between all flash units. Flash for 2-3 seconds with the ink deposit reaching 150-250°F (65-121°C). Ink should be
dry and without tack.
Cure at 325°F (162°C) over a 60-90 second period, depending on oven type and thickness of ink deposit. A thicker deposit will take
longer to cure as the heat must penetrate through the entire ink layer.
Use any of the commercially available products for the cleanup of plastisol inks.
QCM Plastisol Ink contains no leaded pigments and, when properly disposed of, has no environmental impact. Use a screen wash
for plastisols for cleanup. Scrape screens carefully and store ink for reuse. Minimize unusable scrap ink by segregating ink by color.
QCM PPR-901 Black pigment can be used to convert old ink into black ink for waste elimination.
PRODUCT DATA SHEET