RUTLAND ES0468 SPARKLE SILVER

RUTLAND ES0468 SPARKLE SILVER

Your Price: $0.00
Part Number:ANC00676

Choose Options

Container Sizes
1 Gallon
5 Gallon
Quart
Technical Data Sheet #221
Revised 07/17/08
Wet Ink Tack Low
After Flash Tack N/A
Surface
Appearance Glossy
Opacity/Viscosity High/Medium
Bleed Resistance N/A
Gel Point/Flash
Time
160°F (71°C.)/ decreases
with deposit thickness
Fusion
Temperature 320°F (160° C.)
Squeegee
Hardness Firm
Squeegee Blade Sharp
Squeegee Angle 45°
Squeegee Speed Slow to Medium
Underlay N/A
Emulsion Capillary Film or direct
emulsion
Mesh Count 33T mc in (13 mc cm)
Extender N/A
Thickener N/A
Storage 65°F to 95°F (18° C to 33° C)
Avoid direct sun
Cleanup Biodegradable screen
washes
MSDS #1
Color Range Silver, Gold
Substrate Type Cotton or 50/50 Poly
Substrate Color(s) Light, Medium, & Dark
fabrics
Specialty Inks
NA Sparkle Glitter Series
ANY APPLICATION NOT REFERENCED IN THIS TECHNICAL DATA SHOULD BE PRE-TESTED OR CONSULTATION SOUGHT WITH RUTLAND’S APPLICATIONS
LABORATORY PRIOR TO PRINTING. CALL 704-553-0046 EXT. 192 FOR MORE INFORMATION.
Description
NA Sparkle Glitter gives a festive look to otherwise flat boring print designs. Use this glitter to decorate
the garment for festive occasions and special events. The large particle glitter flake provides plenty
of sparkle and glimmer.
Features
• Short body and very low wet tack for easy printing.
• Easy to use, no viscosity modifications necessary.
• Silver Glitter can be tinted with up to 10% Color Boosters to make Glitter Colors.
• Extreme high gloss when printed in thick film.
Application
Print Glitter inks through a 33T mc in (13 mc cm) mesh screen, straight from the container. Maximum
flood of ink into mesh count results in a smooth coat of glitter on the fabric surface. It is recommended
to coat the inside of the screen mesh with emulsion for easy clean up. Glitter particles are opaque and
may be printed on white, light, medium or dark 100% cotton or polyester/cotton without an underlay.
They may also be applied as a cold peel transfer. When using a transfer, print through a 33T mc in (13
mc cm) mesh, gel at 200ºF (94ºC) and transfer at 350ºF (177ºC) to 375ºF (191ºC) for 8 to 10
seconds. Peel cold. Refer to technical literature provided by paper manufacturers regarding the correct
papers to use for cold peel and specialty products.
Recommended Printing Techniques
Special Recommendations
• Plastisols are THERMOPLASTIC, requiring heat for fusion.
• Stir plastisols prior to printing.
• Do not dry clean.
• Do not bleach.
• Do not iron image area