NPT S.H.A.P.E Extender Base
ES0840 is used to extend a plastisol ink and to make it print with a softer hand. ES0840 may be mixed in at any ratio but it will reduce the opacity and color strength of the ink. The mixture can print through a wide variety of mesh ranges and will cure at 320 degrees F. (160 degrees C.) Only mix with NPT plastisol inks to maintain the non-phthalate status.
- Non-Phthalate formulation to comply with new regulations restricting phthalates.
Rutland Plastic Technologies does not knowingly add plasticizers containing the phthalates listed and outlined in California Bill 1108, CPSIA HR-4040 and Oeko-tex Standard 100. The plasticizers identified may include di-(2-ethylhexyl) phthalate (DEHP), dibutyl phthalate (DBP), benzyl butyl phthalate (BBP), diisononyl phthalate (DINP), diisodecyl phthalate (DIDP), di-n-octyl phthalate (DnOP), (DIBP) Di-iso-butyl, and (DMP) Dimethylphthalate, including esters of ortho-phthalic acid and are not direct ingredients in the manufacture of Claira High Opacity Non-Phthalate Inks. Rutland Plastic Technologies does not test the final product for amounts of the aforementioned phthalate plasticizers and esters and encourages all users to conduct testing for their intended use.Disclaimer: Not all Rutland products are available in every country. Please check with your local representative for availability. The data presented in this leaflet are in accordance with the present state of our knowledge, but do not absolve the user from carefully checking all supplies immediately on receipt. We reserve the right to alter product constants within the scope of technical progress or new developments. The recommendations made in this leaflet should be checked by preliminary trials because of conditions during processing over which we have no control. Recommendations for use do not constitute a warranty, either express or implied, of the fitness or suitability of the products for a particular purpose.
Product Overview:Brand: Rutland
Product Code: ES0840
Application: Screen Printing
Sub Category: Base
Best Used By: 12 months
Performance:After Flash Tack: Decreases with increased mesh
Angle: 10° - 20°